(4) Adjustment of the Original Size Detecting Board
◆Important
•
This adjustment must be made after the Original Size Detecting Board has been replaced.
1. Lower the Original Cover with no paper on the Original
Glass.
1139D230CA
1
0
Stop
7
2. On the control panel, press the Stop Key, Multi-Copy
Key "0," Stop Key, and Multi-Copy Key "1," in that
order, to set the copier into a state ready to enter a
particular Tech. Rep. Mode.
3. Press Multi-Copy Keys "1" and "7" to set the copier
into the F7 Test Mode. (At this time, the Multi-Copy
Display shows "F7.")
1139D019CA
Start
Panel reset
4. Press the Start Key to let the copier make the
adjustment.
5. After the adjustment has been made, press the Panel
Reset Key twice (or turn OFF the Power Switch) to
return the copier back into the normal mode.
During the adjustment, the Start Key is lit up orange.
It turns to green as soon as the adjustment is
completed.
(It takes about 2 sec. to make the adjustment.)
NOTE
D-67
To Next Page
Loading...
