9. Parts/Supplies Life Counter Mode
•
This mode shows on the Magnification Ratio Indicator and Multi-Copy Display the number of
copy processes to which different parts or supplies have been subjected. Meanwhile, the
Magnification Ratio Indicator also shows the symbol representing the part or supply.
Types of Parts/Supplies Life Counters
Order Part/Supply
Magnification Ratio
Indicator
Multi-Copy Display
1 Imaging Unit X X
2PC Drum X X
3 Developer X X
4 Cleaning Blade X X
NOTE 1: For each count, the Magnification Ratio Indicator shows the symbol representing the
part/supply and the ten-thousands, thousands, and hundreds digits of the count,
alternately. While the Multi-Copy Display shows the millions and hundred-thousands
digits, and the tens and ones digits of the count, alternately.
Example:
Magnification Ratio
Indicator
Multi-Copy Display
IU 01
345 78
IU Count: 134,578 copy processes
Shown alternately
Setting Procedure
(1) With the copier in the state ready to enter a particular Tech. Rep. Mode, press "8" to set the
copier into the Parts/Supplies Life Counter Mode.
(2) Press the Paper Select Key, and the first life count appears on the Magnification Ratio
Indicator and Multi-Copy Display. Press the Paper Select Key to obtain the count of each
Part/Supply Life Counter. After all counts have been shown, the copier is then ready to
receive a clear command.
Clearing a Life Counter
(1) Press the Paper Select Key to show the count of the Part/Supply Life Counter to be cleared.
(2) Press the Clear Key.
Pressing the Stop Key immediately after the Clear Key has been pressed will undo the clear
command.
Note that the IU Counter is not cleared.
NOTE 2: All Part/Supply Life Counters are cleared automatically when the F8 operation is
completed normally.
S-21
To Next Page
Loading...
