4
ADJUST MODE
•
Whenever the RAM PWB has been replaced, or memory cleared for any reason, be sure to
make the Adjust Mode settings exactly the same way as indicated on the label inside the Front
Door (which are the factory settings).
Types of Adjust Modes
Multi-Copy
Key
Mode Type Mode Name Description
0A0
Lens Focal Length Adjustment Adjusts the focal length of the
Lens.
1A1
Lens Full Size Position Correction Corrects Lens-to-Lens variations
in full size position.
2A2
Mirror Full Size Position Correction Corrects Mirror-to-Mirror variations
in full size position.
3A3
Feeding-Direction Magnification
Adjustment
Adjusts the magnification ratio in
the feeding direction in the scan
mode.
4A4
Full Size Registration Adjustment Adjusts registration in the full size
mode.
5A6
Book-B Scan Registration
Adjustment
Adjusts the Registration of B-Scan
for Book mode.
6A11
Enlargement/Reduction
Registration Adjustment
Adjusts registration in the
enlargement/reduction mode.
7A12
Leading Edge Erase Width
Adjustment
Adjusts the leading edge erase
width provided by the Unexposed
Areas/Edge Erase Lamp.
8A13
Trailing Edge Erase Width
Adjustment
Adjusts the trailing edge erase
width provided by the Unexposed
Areas/Edge Erase Lamp.
Setting Procedure
(1) With the copier in a state ready to enter a particular Tech. Rep. Mode, perform the following
steps to set the copier into the Adjust Mode.
1) Press the Stop Key.
2) Press the Start Key.
(2) Press the Multi-Copy Key corresponding to the desired Adjust Mode number and press the
Start Key. Then, the current setting value appears on the Multi-Copy Display.
(3) Press the Clear Key to clear the current setting value.
(4) Using the Multi-Copy Keys, enter the new setting value and then press the Start Key to
validate the setting.
If the setting value entered is illegal, it blinks.
Leaving the Adjust Mode
To leave the particular Adjust Mode:
•
Press the Panel Reset Key twice.
•
Turn OFF, then ON, the Power Switch.
S-25
To Next Page
Loading...
