◆ Paper Feed Cabinet Take-Up Misfeed Clearing Procedure
Symptom Step Check Item Result Action
•
Paper is not taken
up at all. 1
Is the paper being used up
to product specifications? NO
Instruct the user to use the
paper that is up to product
specifications.
•
Paper is
stationary before
the Paper
Take-Up
Detection Sensor.
2
Is the paper curled, waved,
or damp? YES
Change the paper.
Instruct the user in how to
store the paper.
3
Is the Paper Take-Up Motor
turning when the Start Key
is pressed?
YES Check for possible overload.
NO
Replace PWB-A or PWB-A
(PF-201).
Check the Motor.
4
Is the Paper Take-Up Roll
or Separator Roll deformed,
worn, or dirty with paper
dust?
YES
Clean or replace the Paper
Take-Up or Separator Roll.
•
Paper is
stationary before
the Vertical
Transport Rollers.
5
Is the output signal from the
Paper Take-Up Sensor
being properly input to
PWB-A (PF-201)?
YES
Replace PWB-A or PWB-A
(PF-201).
*
Does the voltage across
PJ9A-2 (3rd Drawer) or
PJ8A-2 (4th Drawer) on
PWB-A and GND change
from DC5V to DC0V when
the Sensor is blocked by
a sheet of paper?
NO
Check the Actuator for
operation.
Check the Paper Take-Up
Sensor.
6
Is Vertical Transport Drive
Motor M21 turning when the
Start Key is pressed?
YES Check for possible overload.
NO
Replace PWB-A or PWB-A
(PF-201).
Check the Motor.
7
Is the Vertical Transport
Roller or Guide Plate
deformed, worn, or dirty
with paper dust?
YES
Clean or replace the
Vertical Transport Roller or
Guide Plate.
Continued on next page
T-13
To Next Page
Loading...
