Minolta EP1080 - ATDC Sensor Failure

7-6. ATDC SENSOR FAILURE
A defective ATDC Sensor (C0F30) is detected under any of the following
timings:
*
The ATDC Sensor output remains 0.5V or lower for a consecutive
2-second period during a period from 2 seconds after the Imaging Unit has
been energized until it is deenergized.
*
The ATDC Sensor output remains 4.5V or higher for a consecutive
2-second period during a period from 2 seconds after the Imaging Unit has
been energized until it is deenergized.
M-22