2. Detailed Instructions for Indicator Lights
1139O6012A
Close the Front Door.
Plug the Power Cord into the
Wall Outlet.
Turn ON the Power Switch.
This with cause the wait indicator
to be shown on the control panel.
5
1139U011AA
The copier automatically start
the charging cycle for
approximately 5 minutes.
During this cycles, do not open
the Front Door.
During this cycle, six segments
of the ones digit LED on the
Magnification Ratio Indicator
forming a "0" light up and go out
one after another, indicating that
the copier is being charged with
starter.
When the copier has been
completely charged with Starter,
the indication on the
Magnification Ratio Indicator
changes to "100" and the cycle
stops.
If "E1" or "E2" is indicated on
the Magnification Ratio
Indicator, the tape has not been
removed from the Starter Bottle.
Swing down the Front Door and
remove the tape and perform the
starter charging procedure again.
If "E1" or "E2" is indicated again
call your Technical
Representative.
1139U012AA
6
7
8
Chapter 5
When an Indicator Lights Up
127
To Next Page
Loading...
