Interleaf EP5000/EP4000 SWITCHES ON PWBs, TECH. REP. SETTINGS
97.04.01
S-29
Tech. Rep. Mode " Counter
Touch Panel
Display
Operation
Maintenance Five different values (counts) can be set for the Maintenance Counter. Each
counter is increased by 1 each time a copy is made and, when the preset
count is reached, the maintenance call reminder message and maintenance
code “M1” appear on the Touch Panel.
Note: Whether the maintenance call reminder message is given or not de-
pends on the setting made for “Maintenance” of “Tech. Rep. Choice.”
Also, copying is not inhibited even when the reminder message ap-
pears.
<Setting a Count>
1. Using the B or Y key, select the counter to be set.
2. Enter the value from the 10-Key Pad.
<Clearing the Set Value/Count>
Using the B or Y key, highlight the count to be cleared, then press the Clear
key.
Note: If a count is accidentally cleared, pressing the Interrupt key will undo the
clear operation.
Port/option Shows the frequency of use of each of the different parts of the copier includ-
ing options to serve as a guideline for the maintenance time for the Tech. Rep.
<Port/Option 1/3>
Display Description Display Description
Manual Feed No. of sheets of paper
fed from the Multi By-
pass Tray
3rd Drawer No. of sheets of paper
fed from the 3rd Draw-
er
1st Drawer No. of sheets of paper
fed from the 1st Draw-
er
4th Drawer No. of sheets of paper
fed from the 4th Draw-
er
2nd Drawer No. of sheets of paper
fed from the 2nd Draw-
er
5th Drawer No. of sheets of paper
fed from the 5th Draw-
er
<Port/Option 2/3>
Display Description Display Description
ADF
Entrance
No. of sheets of paper
fed through the ADF
take-up section.
Sorter No. of sheets of paper
fed out of the Sorter
ADF Reverse No. of originals fed
through the turnover
unit of the ADF
Staple No. of stapling se-
quences performed
DUP No. of sheets of paper
fed from the Duplex
Unit
Punch No. of punching se-
quences performed
To Next Page
Loading...
