D-39
1136D155AA
1156D058AA
1156D059AA
1156D060AA
Rear
Front
1136D157AA
5. Remove three screws and the Main Hopper.
6. Unplug one connector and remove three screws and the
Sub Hopper.
7. Remove two screws and the Developer Scattering Pre-
vention Plate.
NOTE
Do not remove the Doctor Blade Assy, as a changed Db
could result.
NOTE
Install the Developer Scattering Prevention Plate so that
its seal is placed behind the side seals of the Developer
Mixing Chamber.
8. Dump the developer out of the Developing Unit.
To Next Page
Loading...
