D-20
1156D028AA
(7) Cleaning of the Upper and Lower Synchronizing Rollers
1136D092AA
1134D027AA
(8) Replacement of the Paper Dust Remover
1136D093AA
Rear
1136D094AA
11. Remove the Upper Synchronizing Roller.
1. Swing down the Front Door and slide out the IU.
2. Using a brush or a soft cloth dampened with alcohol, clean
the Upper Synchronizing Roller.
3. Swing down the Transport Section Release Lever.
4. Using a brush or a soft cloth dampened with alcohol, clean
the Lower Synchronizing Roller.
1. Swing down the Front Door and slide out the IU.
2. Loosen the screw that secures the Paper Dust Remover
Assy at the rear of the copier.
3. Remove the screw that secures the Paper Dust Remover
Assy at the front of the copier.
4. Remove and replace the Paper Dust Remover Assy.
5. When only the Paper Dust Remover is to be replaced, affix
the new one along the reference line as shown on the left.
To Next Page
Loading...
