1716
INSTALLING BATTERIES
Checking Batteries
The lamp on the control panel glows or blinks when the batter-
ies are low.
When glowing; Power is low. The bat-
teries will need to be replaced soon.
When blinking; Insert new batteries.
Flash cannot be used.
• Check the orientation of the batteries if nothing appears when the con-
troller’s flash on/off button is pressed.
Removing From The Camera
While pressing the mounting-foot
release button , remove the
controller .
Attaching To The Camera
Push the mounting foot firmly
onto the camera until it stops.
• The controller locks in place automati-
cally.
• If the camera’s built-in flash is raised,
lower it before attaching the controller.
ATTACHING AND REMOVING CONTROLLER
To Next Page
Loading...
