Minolta Maxxum 8000i - Page 31

Without Fill Flash
The camera's sync terminal accepts PC-type
sync cords from flash units that do not have a
hot-shoe contact In these cases, the shutter
speed should be set manually to 1/180 sec. or
slower. TTL-flash metering does not operate
with such units. To determine the aperture set¬
ting required for correct exposure, refer to the
flash's instruction manual, or use a flash meter.
57
wbRtsR
Flash Operation with i-series Flashes
Exposure Mode
Operation
P.s
Flash fires automatically when required*
A
Flash fires each time the shutter is released, and X-sync speed is set
to 1 /200 sec. Any aperture can be set.
M
Flash fires each time the shutter is released. Any aperture, and any
shutter speed, from 1 /200 to 30 sec. can be selected.
58