Minolta Maxxum 8000i - Accessories.64

PROBLEM
CAUSE
SOLUTION
Camera can't be shifted out
of P mode
Creative Expansion Card in use
Use the card key to switch the
card off.
If the Customized Function
Card is being used, reset the
program.
Single-frame advance can't
be selected
Exposure Bracketing Card or
Automatic Program Shift
Card in use
Switch the card off, then reset
the film-advance mode
Flash doesn't fire or
signal doesn't appear
Flash's power switch at OFF
position
Flash not attached correctly
Switch the flash on.
Attach the unit so that it locks
in place with a click.
Focus is not adjusted when
using flash
Distance to subject is too close
or too far
Subject's reflectivity is too low
for autofoucsing
Check that the subject is within
the flash range.
Focus on another subject at the
same distance away as the
main subject.
Card system does not
function
Card not installed correctly
Install the card correctly.
ACCESSORIES
Creative Expansion Cards
The Creative Expansion Card system provides a
unique way to expand the 8000i's capabilities to
meet specific needs.
Although illustrations in the manuals for
some of the cards show a different camera
body, card operation with the 8000i is correct
as described.
Multiple Exposure Card — Designed exclu¬
sively for the Maxxum 8000i, this card allows
you to make up to nine exposures on the same
frame.
Besides its standard mode, in which each ex¬
posure in the sequence is made at the “normal”
exposure value, the card offers “Fade-in” and
“Fade-out” modes that produce a series of grad¬
ed exposure changes from the normal value.
64