Working with the printer
7
7-7
Printing out the configuration page
Print out the configuration page in order to check the configuration of your
printer.
1
Make sure that:
- the “Fault“ and “Paper“ lamps are off, and
- the “Stand-by“ lamp is on (but not flashing).
2
Briefly press the control button.
The configuration page is now printed out.
Continuing a print job after an error message
Continue the print job after the following error messages:
when the print job is too complex and the memory capacity of the
printer is inadequate;
when there is no more paper in the feed trays;
when paper of a different format to that set in the printer driver was fed
into the printer.
1
Make sure that one of the above errors has occurred.
2
Press the control button in order to operate the page feed.
The print job continues.
Check the print-out!
If you have continued a print job after an error message, then check
the print-out. It is often the case that not all pages required are printed
out.
To Next Page
Loading...
