Installing optional accessories
8
8-7
8
Lift up the output tray.
9
Enter the new total memory capacity in the printer software (see
chapter 4),
and
print out the configuration page (see chapter 2.
The new total memory capacity should be shown correctly.
?
What if the total amount of memory is not displayed correctly?
→ Check whether the modules were installed correctly.
→ Check the entry in the printer driver.
Would you like to remove a memory module?
To remove a module, press the tabs on both sides of the installation
slot outwards. This will release the module and allow you to take it out.
To Next Page
Loading...
