2
Unpacking, installing and setting up the printer
2-14
Printing out the configuration page
The configuration page should be printed out in order to ensure that the
printer is operating correctly.
1
Switch on the printer.
The printer is ready for use after
approx. 23 seconds.
2
Make sure that:
• the “Fault“ and “Paper“ lamps
are off, and
• the “Stand-by“ lamp is on (but
not flashing).
3
Briefly press the control button.
The configuration page is printed
out.
Be prepared for technical inquiries!
Always have a current configuration page available in the event of a
technical inquiry. Make a note of the printer‘s serial No. on the
configuration page, see chapter 1 (Safety label).
Control button
To Next Page
Loading...
