Minolta XG-7 - Page 18

2.
Leaving the knob
pulled
out,
position
a
film
cartridge in the chamber with the
project-
ing-spool end toward the bottom of the
camera.
Then
push
the back-cover
release
knob
all
the way in,
rotating
it slightly to do
so if necessary.
3. lnsert
the
end
of the
film
leader as shown
into one of the
slots in
the take-up
spool so
that
the tooth is engaged with a
sprocket
hold near the end of the
leader. Make sure
that the end
of
the
leader does
not
project
from
another
slot between tabs orl the
spool.