44
44
4
Section
2
Important Safety InformationImportant Safety Information
Important Safety InformationImportant Safety Information
Important Safety Information
1.1.
1.1.
1.
WW
WW
W
arar
arar
ar
ning!ning!
ning!ning!
ning!
1.1.1.1.
1.1.1.1.
1.1. Products manufactured by us are safe and without risk provided they are
installed, used and maintained in good working order in accordance with our
instructions and recommendations.
1.2.1.2.
1.2.1.2.
1.2. THIS MIRA ADVANCE
MUSTMUST
MUSTMUST
MUST BE EARTHED.
1.3.1.3.
1.3.1.3.
1.3. In accordance with the current edition of ‘The Plugs and Sockets etc.
(Safety) Regulations in force at the time of installation, this Mira Advance is
intended to be permanently connected to the fixed electrical wiring of the
mains system.
1.4.1.4.
1.4.1.4.
1.4.
DO NOTDO NOT
DO NOTDO NOT
DO NOT twist the individual cable cores of the live and neutral conductors,
as this will prevent them from entering the terminal block.
1.5.1.5.
1.5.1.5.
1.5. Make sure that any pipework that could become frozen is properly
insulated.
1.6.1.6.
1.6.1.6.
1.6.
DO NOTDO NOT
DO NOTDO NOT
DO NOT operate this Mira Advance if it is frozen. Allow the Mira Advance to
thaw before using again. The shower unit must not be fitted where it may be
exposed to freezing conditions.
1.7.1.7.
1.7.1.7.
1.7. If water leaks from the pressure relief valve, maintenance will be required
before the Mira Advance can be safely used.
1.8.1.8.
1.8.1.8.
1.8.
DO NOT DO NOT
DO NOT DO NOT
DO NOT fit any form of outlet flow control as the outlet acts as a vent for
the tank body. Only Mira recommended outlet fittings should be used.
1.9.1.9.
1.9.1.9.
1.9. There are no user serviceable components beneath the cover of the Mira
Advance. Only a competent tradesperson should remove the cover.
1.10.1.10.
1.10.1.10.
1.10. If any of the following conditions occur, isolate the electricity and water
supplies and refer to
“To contact us”“To contact us”
“To contact us”“To contact us”
“To contact us”, on the back page of this guide.
1.10.1.1.10.1.
1.10.1.1.10.1.
1.10.1. If the cover is not correctly fitted and water has entered the Mira
Advance case.
1.10.2.1.10.2.
1.10.2.1.10.2.
1.10.2. If the case is damaged.
1.10.3.1.10.3.
1.10.3.1.10.3.
1.10.3. If the Mira Advance begins to make an odd noise, smell or smoke.
1.10.4.1.10.4.
1.10.4.1.10.4.
1.10.4. If the Mira Advance shows signs of a distinct change in performance,
indicating a need for maintenance.
1.10.5.1.10.5.
1.10.5.1.10.5.
1.10.5. If the Mira Advance is frozen.
To Next Page
Loading...
Need help?
General
