EasyManua.ls Logo

Miranda imagestore 750 - Import Config

Miranda imagestore 750
423 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Front Panel Operations Imagestore 750 User Manual
Page 124 Miranda Technologies Inc.
When exporting a configuration, the file generated always encapsulates all
persistent settings currently applied to the system.
Volatile settings are not actually saved within the configuration file; however
the “restart behaviour” of each individual setting is stored. The three possible
restart behaviours of volatile settings are as follows:
Reset as factory-default value
Reset as a user-defined value
Persist from the previous session
The standard restart behaviour of volatile settings is defined within the device
capabilities; however behaviour can be modified via the Configurator tool, a
Windows application accompanying the Imagestore 750 software release.
Such granularity of management over system state gives a high level of
control over system restart behaviour. For example, it may be required on
restart that DSK1, DSK2 and DSK3 be cut-down and unloaded, but DSK4 be
cut up and loaded with the station logo.
Note: In addition to allowing modification of System Settings, the
Configurator tool contains a Route Manager for graphically
setting up audio routing, and a Metadata Mode for controlling
Dolby metadata. Please see pages 342, 357 and 390 for more
information.
Import Config
This option allows the user to select from a list of available configuration
files and choose which one will be used on the next system restart. Use the
joystick arrows (W X) and enter to select and confirm a new file.
For the new setting to take effect the system must be restarted. A prompt will
therefore appear after selecting the new configuration file requesting a system
restart. Use the joystick arrows (W X) to select Yes and press enter.
Alternatively a software reset can be manually selected at a later date.
If the user wishes to cancel any selection made via this menu (assuming no
restart occurred), then re-enter the menu and select “[Keep Current]”. This
means that the active configuration will continue to persist on restart.

Table of Contents