Front Panel Operations Imagestore 750 User Manual
Page 182 Miranda Technologies Inc.
Network Mask
This option displays the unit’s Network Mask (sub-net mask) number and
enables the user to modify it.
The Network Mask number will be shown on the front panel display and
each value can be adjusted between 0 and 255.
The number is in four blocks separated by full stops, for example
>255<255.0.0
The mask number is set for Class B addresses and should only modified in
consultation with your IT department.
To adjust the number, refer to the IP Address section (see above).
Pressing enter to accept the change will then display the message ‘Updating
EEPROM’ shortly followed by ‘Restart to apply new setting’.
Restart the Imagestore 750 by selecting ‘Software Reset’ or ‘Restart System’.
Gateway Address
This option displays the unit’s Gateway Address and enables the user to
modify it.
The Gateway Address will be shown on the front panel display and each
value can be adjusted between 0 and 255.
The number is in four blocks separated by full stops, for example:
>255<255.255.255
The factory default option is disabled and should only modified in
consultation with your IT department.
To Next Page
Loading...