Standard Mixfiles Imagestore 750 User Manual
Page 328 Miranda Technologies Inc.
on the program output via the delay banks. It is also possible to route a copy
of the pass-through audio to the preview outputs by using preview mode 8.
Note: Preview mode 8 is not part of the standard preview modes but
can be activated (using the automation or GPI) with the ‘j6’
command:
j608:
7.1 Mixfile Variants
The following variants of 7.1 surround mixfile ship as standard with the
Imagestore software. The names are as will appear on the front panel.
7.1_dualVO.mix
This mixfile is designed for 7.1 surround embedded AB mixing with dual
AES voice-over onto embedded output. It collects audio from the first 8
channels of the A and B inputs and mixes these to the program output,
incorporating dual voice-over insertion. Both voice-overs use the dual voice-
over matrix described later in this document. Voice-over 1 is on AES input
pair 1 and voice-over 2 is sourced from AES input pair 2.
7.1_VO_eply.mix
This mixfile is designed for 7.1 surround embedded AB mixing with single
AES voice-over plus Easyplay onto embedded output. It collects audio from
the first eight channels of the A and B inputs, and mixes these to the program
output. In addition eight channels of Easyplay can be inserted on a one-to-
one basis onto the first eight channels of the AB mix output, and this is
controlled by the first voice-over. External voice-over insertion is also
possible on the first eight channels of the AB mix. This uses inputs from AES
input pair 1 and is controlled by the second voice-over.
7.1_ AES_eply.mix
This mixfile is designed for 7.1 surround AES AB mixing with single
Easyplay (no AES voice-over) onto AES output. It collects audio from AES
To Next Page
Loading...