12
Setting Up the Kaleido-X16 Multi-Viewer
Networking Setup
2
• If you would like the system to automatically select a resolution based on information from the
connected display, select Use detected monitor resolution.
• If you would like to manually set (and fix) the resolution, select the desired resolution from the
Default DVI resolution list:
3. Click OK.
The output resolution is adjusted accordingly.
Step 2: Networking Setup
For the Kaleido-X16 multi-viewer to join a TCP/IP network, it must be configured with an IP address, a
network mask, a gateway, and a system name. In addition, a client PC must be configured to communicate
with the multi-viewer. You must also configure any Kaleido-RCP2, and Audio Bridge Terminal units you
may have ordered.
The Kaleido-X16 is shipped with the following default settings:
IMPORTANT: At initial startup, after your system has auto-detected the resolution of the display, it is
strongly recommended that you manually set the output resolution and clear the Use
detected monitor resolution check box.
To Next Page
Loading...
