Kaleido-X16
Quick Start Guide
3
In addition to the above, you will need the following (not supplied):
• Up to 2 displays
• A dedicated 100Base-T Ethernet switch with enough ports for the Kaleido-X16, client PCs, Kaleido-
RCP2, and Audio Bridge Terminals
• Client PC (see below for system requirements)
• Cables (to connect your multi-viewer to video sources, to displays, and to the network):
System Requirements for a Client PC
A client PC running Windows XP (or Windows 7) is required to access the XAdmin Web client, as well as to
run the XEdit application.
Cable type Purpose
CAT-5 For Ethernet connectivity
Display cables Either extension modules—for example Miranda’s DXF-200
(part number DXF-200-B)—or HDMI cables
Video cables Standard coaxial cables with BNC connectors
Note: Do not use a DVI-to-HDMI adapter to connect a DVI cable to your multi-viewer. The adapter would
interfere with the multi-viewer’s AC cable and cause undesirable strain on the connection. You may order
suitable HDMI cables from Miranda—HDMI w/Lock to DVI female cable (1ft), part no. KXC-HDMI-L-DVI.
Minimum Configuration
minimum 1 GB of RAM
minimum Pentium 4 at 1 GHz
Recommended
2 GB of RAM
Pentium 4 at 2 GHz
Hard Disk
At least 125 MB free
To Next Page
Loading...
