100
Managing Kaleido-X Systems
Configuring the System Representation
5 When prompted to confirm, click Ye s.
6On the File menu, click Save.
Changes to the system are saved. If you are not planning on adding these streams back
to your system, then you may now wish to remove logical sources that were based on
them: see
Removing Logical Sources for Removed Programs in a Transport Stream, on
page 160.
Managing Cards in a Kaleido-X System Representation
To configure a Kaleido-X (4RU), Kaleido-X (7RU), or Kaleido-X (14RU) expansion system
1 In the main window, click the System tab, and then click Description/Calibrations on
the second-level tab bar.
The main pane displays the System hierarchical list, and the Tools pane displays the
equipment library when the root of the System list is selected.
2Expand the System root, and the multiviewer.
The card slots appear in the hierarchical list. If you already loaded the factory defaults
for the multiviewer model, then some slots are already populated with a card.
Note: In the case of an expansion system, then you need to first expand the
dual frame element, under which both frames A and B are listed. You can
then configure each of the two frames as described below.
To Next Page
Loading...
