104
Managing Kaleido-X Systems
Restoring Factory Defaults
To restore the XEdit factory defaults for a multiviewer model
1 Right-click the current multiviewer in the System list, and then select the appropriate
multiviewer model—Kaleido-X16-S, Kaleido-X16-D, Kaleido-X
(4RU), Kaleido-X (7RU),
Kaleido-X
(14RU), Kaleido-Modular, Kaleido-MX, Kaleido-IP-2, Kaleido-IP-4 or
Kaleido-IP-6—, from the “replace with...” options on the menu.
Note:
If you are working in online mode, the set of multiviewer models available
from the menu varies according to the current model. If the current model is
a Kaleido-IP, then only the other Kaleido-IP models are available for
selection.
Conversely, if the current model is not a Kaleido-IP, then none of the
Kaleido-IP models are available for selection.
Select... To represent a...
Kaleido-X16-S Kaleido-X16 (single output)
Kaleido-X16-D Kaleido-X16 (dual output)
Kaleido-X (4RU) Kaleido-X (4RU)
To Next Page
Loading...
