115
Kaleido-X
User’s Manual
4 Select the head you wish to calibrate.
5Click the Properties tab.
The brightness and contrast adjustment controls appear. Expand the headings to show
the controls if they are not visible.
6 Use the sliders to adjust the brightness and contrast until you obtain a pleasing
presentation of the video elements on the monitor wall display driven by the selected
head. Alternatively, type values directly in the Red, Green (master), and Blue boxes.
7 If appropriate, you may copy settings from this head to every output head in the system.
For each value you wish to apply globally throughout your system, click the
corresponding Apply to all button.
Note: Moving the Green (master) slider will move the Red and the Blue
sliders by the same amount.
The values must be between 0 and 100.
A good approach is to set all values the same using the Red and Blue sliders,
then to adjust for the best overall presentation using the Green (master)
slider, and finally to fine-tune the color balance using the Red and the Blue
sliders.
To Next Page
Loading...
