130
Calibrating the Kaleido-X
Router Output Calibrations
You can type the value directly in the boxes, or use the slider controls.
Router Output Calibrations
Calibrating Switch Field Selection
To calibrate switch field selection for a router module
1 In the main window, click the System tab, and then click Description/Calibrations on
the second-level tab bar.
A hierarchical list representing the current system appears.
2 In the list, expand the multiviewer you wish to calibrate.
3 Expand the appropriate router module, and then click Switch field selection.
XDS filtering Set the holding time (between 5 and 360 seconds) for
each XDS metadata element (APS, ASB, CGMS-A; channel
number; elapsed time; network name; program
description, ID, name, length, and type; station ID; TSID
name; time of day; time zone; V-chip rating).
DTVCC holding time Set the delay (between 15 and 360 seconds) after which
closed captions (708) are cleared:
Note: This section applies to the Kaleido-X16, Kaleido-X (7RU), and
expansion systems only.
To Next Page
Loading...
