236
Creating Layouts
Configuring Timers
• Loop: The timer restarts and repeats its cycle (not available with the Remaining
timer mode).
• Stop: The timer stops.
• Overrun: The timer counts through its specified end point, and then continues
(when Overrun is specified, the timer always counts up).
6If you chose Loop as a timer end mode, specify the number of times the loop should
repeat.
7 Specify a Preset duration.
8 Specify a Start time.
9 Choose a synchronization source from the Time code reference list— either an
embedded time code signal from a video source, an LTC input (if available), or the
internal clock time (default).
To Next Page
Loading...
