18
Getting Started
Loading a Layout
Two LEDs are visible on the front panel, one for each power supply. When lit, they both
indicate the same status:
When the ABT is powered up, all three LEDs will be orange until the boot sequence is
terminated. This is a visual indicator that the LEDs are functioning properly.
Loading a Layout
If your system was configured prior to shipment, then the designated layout will show up
on all displays. Otherwise, a gray screen will appear with the following message in the
middle:
“No layout has been assigned to this room. Please load a layout.”
To load a layout on the monitor wall
1 Connect a mouse to the Kaleido-RCP2 or RCP-200 (if available) and log on to the
multiviewer from the control panel, if you have not already done so (see
Logging on to
the Monitor Wall Using a Remote Control Panel, on page 29).
Alternatively, connect the mouse directly to one of the USB ports on the multiviewer.
2 Right-click anywhere on the monitor wall, point to Monitor wall (if you clicked a layout
element), and then click Load layout on the shortcut menu.
Monitor wall shortcut menu
Orange Activity
Red Hardware fault
Flashing red Upgrading firmware
Color Board Status
Green Normal
Flashing green Normal, rebooting
Orange Warning
Flashing Orange Warning, rebooting
Red Hardware fault
Flashing red Upgrading firmware
Color Board Status
To Next Page
Loading...
