308
Routers & Kaleido-X
Importing Router Configurations from an NV9000 System Controller
13 In the Destinations tab, adjust the number of destinations if you wish, by typing the
desired number in the Size box, and then click Auto map if needed to configure all
KX
Router destinations as monitor wall destinations.
14 Click the System tab, and then click Router connections on the second-level tab bar.
15 Specify the appropriate physical connections between your multiviewer inputs and the
external router outputs that feed them.
See Router Connections on page 333, for
details.
16 Click the Layouts tab.
17 Open the layout you wish to use, and then assign monitor wall destinations to monitors
in your layout, as required.
See Assigning Logical Sources or Monitor Wall Destinations
to Monitors on page 209 for details.
You may also assign a logical source to each monitor, if you wish.
18 For every monitor to be used as a monitor wall destination, specify the appropriate text
level, based on the information you wish the UMDs to display.
See Configuring
Dynamic UMD Text on page 242, for details.
19 On the File menu, click Save, and then click the LOAD button on the toolbar.
The layout appears on the monitor wall.
Renaming Physical Routers
To rename a physical router
1 In the Routers list, click the physical router you wish to rename.
2In the Router configuration tab, type the new name in the Router name box, and then
press Enter.
You may rename the associated logical router, for consistency.
To Next Page
Loading...
