324
Routers & Kaleido-X
Configuring a Router Controller
So, for example, if you press a button on the external panel that is set up to make a
crosspoint change on logical router matrix ID 0, the Kaleido-X software will receive this
command, look up matrix ID 0 to find the physical router it is mapped to, and then forward
the crosspoint change to the physical router using the appropriate protocol. In such cases,
the Kaleido-X software acts as a “protocol translator” for the control panel.
To add a Snell (Pro-Bel) SW-P-08 (or equivalent) router controller
1Click and drag Router controller (SW-P-08) from the Equipment library to the System
hierarchical list.
2 When prompted, type a name for the router controller, and then click OK.
3Click the Interconnects tab, draw a line between the multiviewer and the new router
controller, and then click the line.
4In the Properties tab, click the RS-422 communication port box, and then choose a
multiviewer output from the list.
Click the line to configure
the connection properties
To Next Page
Loading...
