334
Routers & Kaleido-X
Router Connections
1 An operator right-clicks a monitor and assigns a logical source by using the Assign
Source window.
2 The Router connections tab in XEdit allows you to map physical connections between
a number of INPUT connectors on the multiviewer and the upstream router’s OUTPUTs
that feed them, which allows the Kaleido-X software to determine the crosspoint
switch needed.
3 The multiviewer sends this command to the external router, over a serial or TCP/IP
connection, using the appropriate protocol.
4 The external router redirects the specified source signal.
5 The new signal follows the physical connection to one of the multiviewer inputs
reserved for this purpose, is processed, and appears on the monitor wall.
Note: It is also possible to select a source from the Assign [router] input
menu. However, as of version 5.20 of the Kaleido-X software, Miranda
strongly recommends configuring the KX Router logical router to cover all
routing purposes within the multiviewer system.
Assign Source window on the
monitor wall
DVI outputs to monitor wall
INPUTs 1 to 96 entering KXI
cards
OUTPUTs 1 to N exiting router,
some of which are physically
connected to KXI INPUTs
SOURCES (e.g. CAM_1,
SAT_1)entering router
To Next Page
Loading...
