346
Tally Interface Devices
Sony Production Switcher
• On an SCU (MKS-8010A or MKS-8010B), use the 15-pin connector labeled EDITOR
PANEL, with an adapter.
Sony System Control Unit (MKS-8010A)
Sony System Control Unit (MKS-8010B)
To use a serial tally from an SCU model MKS-8010A or MKS-8010B, a 15-pin-to-9-pin
adapter is required, with pinouts as follows:
No adapter is required for SCU model MKS-8010, which has a DE-9 connector with the
following pinout:
In addition, on Sony menu page 7367, you must enable R and G serial tallies on the SCU
port.
MKS-8010A or MKS-8010B
(15-pin)
SCU
(Signal)
Serial tally device
(9-pin)
2 RX- 2
3 TX+ 3
10 RX+ 7
11 TX- 8
4 GND 4
MKS-8010
(9-pin)
SCU
(Signal)
2 RX-
3 TX+
7 RX+
8 TX-
4 GND
Note: See RS-422 Connection Diagram, on page 22 for pinouts on the
multiviewer.
To Next Page
Loading...
