391
Kaleido-X
User’s Manual
Network Considerations & Port Usage
Network Considerations
Kaleido-X, Kaleido-X16, Kaleido-Modular
Kaleido-X, Kaleido-X16, and Kaleido-Modular multiviewers generate a low to moderate
amount of client-to-server data traffic, and therefore have a minimal bandwidth impact on
a network.
Kaleido-IP
In the case of a Kaleido-IP multiviewer, it is possible to add and configure up to 3000
programs without exceeding the network’s bandwidth or the unit’s decoding resources.
Refer to the Kaleido-IP video inputs section (under “Supported Input/Output Formats”), in
the Kaleido-X Release Notes, for details on the number of streams and total streaming
bandwidth supported.
The Kaleido-IP multiviewer joins a multicast group only when decoding is required, that is
when a source is being monitored on the wall. In addition, streams that are not decoded are
joined momentarily in a polling manner—one stream at a time—to update the PMT and
PAT information. The Kaleido-IP leaves the multicast group as soon as a change of layout
implies that a different set of streams must be decoded.
However, if your situation involves frequent changes of layout (e.g., loading a new layout to
the monitor wall every minute), then, when you are creating or editing a layout, make sure
to terminate XEdit’s connection to the Kaleido-IP once configuration tasks are completed
(see
Disconnecting from a Multiviewer, on page 69).
Cannot upgrade
card in this slot.
Move card to frame
A or swap with
card in Frame A.
Upgrade will
proceed after
current upgrade.
This message will appear on an expansion frame
if frame B contains cards running
software/firmware older than version 3.00. The
upgrade will not be permitted on any card in the
frame until these cards are removed from frame
B. To upgrade these cards, transfer them to
frame A.
x
Cannot continue
the upgrade until
card in this slot is
moved to frame A.
This message will appear on an expansion frame
with expansion enabled and with cards in frame
B running software/firmware older than version
3.00. To upgrade these cards, transfer them to
frame A.
x
Upgrade dashboard messages (continued)
Message Description 7RU 4RU X16 KMV
To Next Page
Loading...
