409
Kaleido-X
User’s Manual
3 Press ENTER again (by default, there is no password).
The message “Access granted” will appear on the LCD display if the login is successful. If
a mouse is connected to the Kaleido-RCP2, then you should be able to see and move
the mouse pointer on the monitor wall.
For more information, refer to the Kaleido-RCP2 Guide to Installation and Operation, available
on the DVD that shipped with your system, and from Miranda’s support portal.
Configuring an Audio Bridge Terminal
The Audio Bridge Terminal (ABT) is an external audio multiplexer/serializer for the Kaleido-
X. The Kaleido-X supports up to 128 inputs, and all of the video input connectors are
located on the rear panels associated with the KXI series of cards.
There is not enough space on the rear panels to also include the audio connectors. The ABT
provides connector space for the audio signal inputs, and multiplexes all the audio signals
into combined serial feeds on coaxial cables that connect to the KXI cards.
To configure the IP address and other network settings of the ABT
1 Connect a PC to a switch.
Note: If at any time the message “Target system is offline” or “No login list
available” appears on the LCD display, press the ESC, ENTER and DEL keys
simultaneously and go back to
step 1.
Note: The KMV-3901/3911 is not compatible with the Audio Bridge
Terminal.
Note: The ABT is powered through the RJ-45 Ethernet connector. There is
no power ON/OFF button, so the device is ON whenever a powered Ethernet
cable is connected.
To Next Page
Loading...
