49
Kaleido-X
User’s Manual
Changing an Internal Router Crosspoint
To change a crosspoint in the internal router
1 Right-click the appropriate composite or video monitor on the monitor wall.
2 On the shortcut menu, point to Send to [router] output (where [router] will be the
name of the first logical router mapped to your multiviewer’s router outputs), navigate
to the appropriate logical output, and then select it.
• The physical input information (Phy) may indicate “Unresolved” in
situations such as the following:
• the router that provides the current source to the multiviewer is not
configured properly;
• the router interconnections are not configured properly;
• there is no communication between the router and the multiviewer;
• an input card was removed (in the case of a Kaleido-X multiviewer
model);
• there are not enough multiviewer inputs connected to the router to
handle all the signals being routed to monitor wall destinations.
Notes
• This feature is only available on Kaleido-X (7RU), Kaleido-X (14RU), and
Kaleido-X16 multiviewers, with the SDI Router Output option, and whose
internal router is properly configured within the first level of the KX Router
logical router See
Configuring a Multiviewer’s Internal Router, on page 326
for more details.
• In the case of a Kaleido-X (14RU) expansion system, to be able to send a
video signal to a router output on either frame, the internal routers must
be connected by expansion cables, and router expansion must have been
properly configured in XEdit. Refer to “Configuring Router Card Expansion”
in the Kaleido-X (7RU) Hardware Description & Installation Manual, for
more information.
Notes (continued)
To Next Page
Loading...
