50
Operation of the Monitor Wall
Changing Crosspoints
The source signal displayed on the monitor is routed to the selected destination.
Changing an External Router Crosspoint
To change an external router crosspoint
1 Right-click a composite or video monitor on the monitor wall.
2 On the shortcut menu point to Assign [router] input (where [router] will be the name
of a logical router whose outputs are connected to the multiviewer inputs), navigate to
the input you wish to assign to the monitor, and then select it.
Note: As of version 5.20 of the Kaleido-X software, when a multiviewer
manages an upstream router, you should manage the router’s physical
sources as logical sources within the multiviewer system (see
page 157).
Router sources can thus be assigned to monitor wall elements transparently,
just as sources connected directly to the multiviewer’s inputs (see
Assigning
Sources to Monitors, on page 44). The KMV-3901/3911 multiviewers do not
support the procedure described below.
To Next Page
Loading...
