52
Operation of the Monitor Wall
Using Timers
.
To configure an interactive timer monitor on the monitor wall
1 Right-click the timer you wish to configure.
2 On the shortcut menu, point to Mode, navigate to the appropriate timer mode, and
then click the desired end behavior.
Alternatively, you can set the mode and behavior directly, by clicking the timer
monitor’s Timer mode, and End behavior buttons:
•Click the Timer mode button to select one of three modes: Overrun, Stop or Loop.
•Click the End behavior button to select one of three modes: Down, Up or
Remaining.
Notes
• Timer monitors display time in HH:MM:SS format. Even if the monitor is
synchronized with an LTC source, frame count is not displayed.
• Using a timer monitor’s Reset, Timer mode or End behavior buttons will
stop the timer, if it was running.
Stop
Remaining
Loop
Down
Overrun Up
To Next Page
Loading...
