54
Operation of the Monitor Wall
Triggering Actions
To configure your assigned timer, by using a numeric keypad
• Press the slash key (“/”) to set the timer mode and end behavior. Keep pressing the key
to cycle through all the available options, until the buttons show the appropriate
settings.
• Press the plus key (“+”) to reset the timer. (This will also stop the timer if it was running.)
• Press the Enter key to start/pause the timer.
• Use the number keys to set or modify the preset time.
Triggering Actions
Triggering an Action from the RCP-200
To trigger a background action from the RCP-200’s programmable knobs
1 If you have yet to assign the action you wish to trigger to one of the programmable
knobs, rotate the knob you wish to program until the action is selected, and then press
the knob.
The action’s name appears above the programmed knob.
2 Press the knob to trigger the action.
Triggering an Action from the Monitor Wall
To trigger a monitor wall action
1 Move the pointer over a monitor associated with the action you wish to trigger.
The pointer changes to a hand icon.
2 If the action is not triggered automatically, click or double-click the monitor.
Triggering GPI Output Events
To trigger a GPI output event
1 In XEdit, configure the appropriate GPI line’s direction as an output (system calibration).
2 Create an action to toggle the GPI output on/off state, and assign it to a monitor.
3 Export the database to the Kaleido-X.
4 Trigger the action by clicking the monitor.
Notes
• An Action’s trigger is determined when the Action is created in XEdit. See
Creating Actions on page 267 for more information.
• To create background actions that can be triggered from the RCP-200’s
programmable knobs, refer to
Creating an Action that can be Triggered
via a Gateway Command, on page 273.
Note: This topic does not apply to the Kaleido-IP.
To Next Page
Loading...
