56
Operation of the Monitor Wall
Triggering Audio Monitoring
This will acknowledge every alarm monitored in the current room.
Acknowledging Alarms by Using an Action
To acknowledge alarms, by using an action
•Create a Unlatch/Acknowledge all action. This action can be assigned to a monitor on
the monitor wall, it can be triggered by loading or unloading a layout, or it can be a
background action.
See Creating Actions on page 267 for details.
Triggering Audio Monitoring
Triggering Audio Monitoring by Using the mouse, the RCP-200, or the
Kaleido-RCP2
To trigger audio monitoring, by using the mouse, the RCP-200, or the Kaleido-RCP2
• Move the pointer over an audio monitor, and then
•click the monitor
• press AUDIO MONITORING on the Kaleido-RCP2
• press the AUDIO MONITOR programmable knob on the RCP-200
This will route the monitor’s audio source to the monitoring output assigned to the
current RCP user.
• Move the pointer over a video monitor, and then
•click the monitor
Note: Before connecting a display or AV receiver to a Kaleido-IP
multiviewer, make sure the multiviewer is powered off. In the advent that
you have connected such a device while the multiviewer was running, you
must restart the multiviewer for audio monitoring to be functional.
See
Restarting and Shutting Down a Kaleido-IP Multiviewer on page 437.
Note: If you have yet to assign the AUDIO MONITOR wall function to one of
the RCP-200’s programmable knobs, rotate the knob you wish to program
until AUDIO MONITOR is selected, and then press the knob. AUDIO
MONITOR appears above the programmed knob.
To Next Page
Loading...
