58
Operation of the Monitor Wall
Setting a Display Monitor’s Output Resolution
Triggering Audio Monitoring by Using an Action
To trigger audio monitoring, by using an action
• Create a Monitor audio action, for the audio source you wish to monitor. This action can
be assigned to a monitor on the monitor wall, or it can be a background action.
See
Creating Actions on page 267 for details.
Setting a Display Monitor’s Output Resolution
With a Kaleido-IP, Kaleido-X, or Kaleido-X16, you can set a display’s output resolution from
the monitor wall. This is useful if you don’t have access to another computer. If there is no
output on a display, you can reset the output resolution to 1280
× 1024 @ 60 Hz, by using a
keyboard shortcut: hold down the Ctrl and Alt keys, and then press R.
•In the case of a Kaleido-X, connect the keyboard to a USB port on the output card
associated with the display. If two displays are connected to this output card, then the
resolution is applied to both. Alternatively, use a keyboard connected to the Kaleido-
RCP2.
•In the case of a Kaleido-X16, connect the keyboard to one of the USB ports on the
multiviewer. If two displays are connected to the multiviewer, then the resolution is
applied to both. Alternatively, use a keyboard connected to the Kaleido-RCP2 (if
available).
Specifying a Display Output Resolution from the Monitor Wall
To set your display output resolution from the Monitor Wall
1 Right click the monitor wall background, and then click Display Resolution on the
menu.
Note: All audio and video monitors are configured by default, with a
Monitor audio action triggered by a single click.
Note: This section does not apply to the KMV-3901/3911, Kaleido-XQUAD,
Kaleido-MX, and Kaleido-Modular-X, which do not support setting a display
output resolution from the monitor wall. For these multiviewers, you can set
your displays’ output resolution by using XEdit, the Densité controller’s local
control panel (or a control panel in iControl, if available).
See Configuring
Displays on page 180, or refer to the Quick Start Guide for your multiviewer,
for details.
Note: If the keyboard is connected to a Kaleido-RCP2, the Keyboard
attribute for the current RCP user must have been set to “US” in XEdit,
otherwise the shortcut may not work (i.e. it could be parsed and converted
to a special character, depending on the selected locale). In the case of a
Kaleido-X, the shortcut will reset the resolution on the active display (the
one where the mouse pointer is located) and on the other display connected
to the same output card, if any.
To Next Page
Loading...
