30 TX3 Touch Screen Installation Manual
Installation
2.4 Installing TX3-TOUCH-S15-B/C/D
Warning: To prevent overheating, do not install any of the TX3 Touch
Screens in direct sunlight.
The surface mount enclosure mounts on the wall. Mount the enclosure right-side
up (the Mircom logo on the door is on the bottom).
You need:
• 4 fasteners appropriate for the wall that you are mounting the enclosure
on.
To surface mount the enclosure
1. Find a suitable location for the enclosure.
2. Mark the back mounting locations of the two top screws. Ensure that at
least one screw is over a wall stud.
3. Place the fasteners halfway into the wall in the two top keyhole locations
and wall stud.
4. Place the enclosure onto the fasteners, then lower it so that the fasteners fit
in the narrow part of the keyholes.
5. Screw the other fasteners into the remaining holes.
6. Tighten all fasteners into place.
7. Proceed with the power supply installation described in section 2.11 on
page 67.
To Next Page
Loading...
