Mirion Technologies UltraRadiac-Plus - Clearing the Accumulated Dose; Reading the Alarm Threshold

Clearing the Accumulated Dose
Clearing the Accumulated Dose
 Press and hold DOSE + CLR/TEST.
 The display will flash for a few
seconds, then clear the accumulated
dose.
 To return to the Rate Mode, press the
RATE key.
Reading the Alarm Threshold
 Press ALARM + RATE or ALARM
+ DOSE.
 You’ll see an H, for High Level
Alarm, displayed.
 To read the Low Level Alarm setting,
press the RATE (DOSE) key again;
the display will show an L.
 Press the CLR/TEST key; the
flashing display will show the
selected (H or L) alarm threshold
setting.
13