Mirion Technologies UltraRadiac-Plus - 5 Setting up the Unit

Chapter 5 Setting Up the Unit
5. Setting Up the Unit
This chapter has been written for the System
Administrator, the person responsible for your
organization’s UltraRadiac-Plus units. It
describes each of the unit’s functions and
gives detailed instructions on how to set and
enable the alarms. This is applicable only if
the functions were not disabled by the
optional Model S900 UltraRadiac Setup
Software.
CAUTION:
To make your changes
permanent, you must go
through the entire setup
sequence outlined in this
chapter.
Exiting the sequence before it
is complete, such as by
changing only one parameter
then waiting 10 seconds for
the display to return to the
Rate Mode, will cause all
changes to be lost when the
unit is turned off.
28