Chapter 5 Setting Up the Unit
• If no Rate Alarm thresholds have been
exceeded, the unit will go back to sleep
for five minutes.
• This wake-sleep cycle will repeat
continuously until the Sleep Mode is
cancelled.
Note: The unit does not accumulate Dose
data while asleep.
Exiting the Sleep Mode
To exit the Sleep Mode:
• Press and hold the ON/OFF key until
the unit starts cycling through the 0–4
startup sequence.
• The unit will then exit the Sleep mode
and enter Rate Mode.
The Data Logging Mode
The Data Log lets you record up to 999
individual dose/rate data pairs, each with an
index number, for later retrieval. This is useful
for performing a survey or for cataloging
readings.
44
To Next Page
Loading...
