The Data Logging Mode
Capturing Data Pairs
To capture data pairs, the unit must be ON
and in the Rate Mode.
• Press the RATE and DOSE keys
together.
• Hold both buttons down until the
displayed number stops blinking (in
about three seconds),
• The next sequential rate/dose pair index
number will appear.
• Release both buttons. The unit will save
the data pair and its index, then return
to the Rate Mode. This process takes
about 10 seconds.
• To record another reading, point the
unit at the location to be recorded and
repeat the process.
Viewing the Data Log
To view the stored data, the unit must be OFF.
• Press the RATE and OFF/ON keys
together.
45
To Next Page
Loading...
