The Data Logging Mode
When the 999th sequence number has been
recorded, the unit will cycle back to the first
sequence number and any new data records
will overwrite the previously recorded data in
that location.
Clearing the Data Log
To clear all stored data, you must be in the
Viewing the Data Log mode. (See the
previous section.)
• While pressing both the RATE and
ALARM keys, press and hold the
CLR/TEST key for two seconds.
• The first index number (0) will appear
• This indicates that all data has been
cleared.
• To return to the Rate/Dose mode of
operation, turn the unit OFF, then back
ON.
47
To Next Page
Loading...
