Attaching the Belt Clip
• Press and hold the ON/OFF key for
about 2 seconds.
− The unit will cycle through the
display startup sequence, then
enter the Rate Mode.
Attaching the Belt Clip
To attach the supplied belt clip, screw the
clip’s two captive retaining screws into the
threaded inserts at the top of the unit’s rear
panel.
Note: To prevent cross-threading damage,
insert each screw loosely, then tighten
them alternately a few turns at a time.
Do not over-tighten.
The Carrying Case
If the belt clip is installed, remove it from the
back of the UltraRadiac-Plus by unscrewing
its two captive retaining screws and lifting the
clip off the unit.
55
To Next Page
Loading...
