miseno MH80120AS User Manual (English)

Questions and Answers:

C
Christopher GregoryJul 27, 2025
What to do if my miseno MH80120AS is not venting out properly?
- R
  rdeanJul 27, 2025
  If your Miseno Ventilation Hood isn't venting properly, there are several potential causes. First, the hood might be too high from the cooktop; adjust the distance to be within 26” to 34”. Also, winds from open windows or doors could be affecting ventilation; close them. Check for blockages in the duct opening or duct work and remove them. Ensure the duct opening direction isn't against the wind, and verify that you are using the correct ducting size, which should be at least 6” or higher.
Z
Zoe WarnerAug 2, 2025
Why is my miseno MH80120AS not working after installation?
- T
  Tara WiseAug 2, 2025
  If your Miseno Ventilation Hood isn't working after installation, there could be several reasons. Ensure the power source is turned on, checking both the circuit breaker and the unit's power. Verify that the power line and cable locking connector are properly connected. Also, check that the wirings between the switch board and control board are correctly connected, and that the Black/White wire or White wire on the switch board is properly connected. If all else fails, the switch board or control board might be defective and need to be changed.
K
Katie CarterAug 6, 2025
What to do if my miseno MH80120AS Ventilation Hood is vibrating?
- J
  Joseph HunterAug 6, 2025
  If your Miseno Ventilation Hood is vibrating, it could be due to a few reasons. Check if the blower is securely in place and tighten it if necessary. A damaged blower wheel could also cause vibration, so consider changing the blower. Lastly, ensure the hood itself is properly secured in place by checking the installation.
M
Matthew CampbellAug 11, 2025
Why is the motor working, but the lights are not on my miseno Ventilation Hood?
- L
  lbrownAug 11, 2025
  If the motor in your Miseno Ventilation Hood is working but the lights are not, the issue is likely with the lights themselves. First, check if the halogen bulb is defective and change it if needed. Also, ensure that the light bulb is tightened properly.
J
Jennifer MercadoAug 16, 2025
What to do if the light works, but the motor is not turning on my miseno MH80120AS?
- H
  Hunter StricklandAug 17, 2025
  If the light in your Miseno Ventilation Hood works, but the motor doesn't turn, it could be due to several reasons. The blower might be defective or seized, requiring replacement. Alternatively, the thermally protected system may have shut down the motor because it was too hot; in this case, the motor will function properly after the system cools down. A damaged capacitor could also be the cause, so consider changing it.

miseno MH80120AS Specifications

General

Brand	Miseno
Model	MH80120AS
Hood Type	Wall Mount
Width	30 inches
Airflow	400 CFM
Lighting	LED
Material	Stainless Steel
Voltage	120V
Number of motors	1
Control type	Push Button
Filter type	Baffle

Summary

Important Safety Notice

Electrical and Fire Hazard Warnings

General warnings to reduce risk of fire, electric shock, and injury from appliance use.

Range Top Grease Fire Precautions

Guidelines to prevent and handle grease fires on the range top during cooking.

Range Top Fire Injury Prevention

Steps to take to prevent injury during a range top fire incident.

Installation and Electrical Safety

Warnings regarding installation, electrical work, and venting requirements.

Electrical Requirements

Installation Codes and Grounding

Adherence to electrical codes, grounding instructions, and wire requirements.

List of Materials

Included Parts and Hardware

Details of parts supplied with the unit and hardware package contents.

Parts Not Supplied

List of components that are not included with the product.

Ducting Calculation Sheet

Maximum Duct Length Guideline

Information on the maximum allowable duct length for optimal air movement.

Mounting Height and Clearance

Mounting Height Recommendations

Specifies minimum and maximum height for installing the hood above the range.

Ducting Material and Configuration

Requirements for duct size, material, and advice on reducing turns.

Handling Damaged Shipments

Instructions for inspecting and handling units damaged during shipment or installation.

Ducting Options

Ducting Fire Hazard Warning

Critical warning against venting exhaust into enclosed spaces.

Common Ducting Configurations

Illustrations showing various methods for venting exhaust air outdoors.

Specifications

Dimensional Views

Technical drawings showing front and top dimensions of the hood.

Electrical Installation

Electrical Work and Safety

Warnings and guidelines for performing electrical work safely.

Power Supply Requirements

Details on the required voltage, frequency, and circuit protection.

Grounding Importance and Method

Explanation of why grounding is necessary and how to ensure it.

Installing the Power Pack

Installer Safety Caution

Warning regarding the need for at least two installers due to hood weight and size.

Cabinet Preparation and Liner Installation

Steps for preparing the cabinet and installing an optional liner.

Power Pack Mounting and Securing

Instructions for lifting, locking, and securing the power pack to the cabinet.

Ducting, Electrical, and Final Checks

Steps for connecting ductwork, electrical, and performing final checks.

Features & Controls

Blower Speed Control

Explanation of how to operate the blower and select speed settings.

Lighting Control

Instructions for turning the lights on, off, and adjusting brightness.

Filter Maintenance

Surface Cleaning Guidelines

Precautions and methods for cleaning exterior surfaces safely.

Stainless Steel Cleaning

Detailed instructions for cleaning and maintaining stainless steel finishes.

Aluminum Mesh Filter Care

How to clean and maintain the aluminum mesh filters.

Removing Aluminum Mesh Filter

Step-by-step guide for safely removing the mesh filter.

Recirculating Kit Installation

Ductless Recirculating System

Explanation of the ductless option and its functionality.

Purchasing Recirculating Components

Information on acquiring the recirculating kit and charcoal filters.

Installing Charcoal Filter

Instructions for correctly installing the charcoal filter.

Light Bulb Replacement

Light Bulb Safety Precautions

Warnings about hot bulbs and the need to turn off power before replacement.

Bulb Replacement Procedure

Steps for removing and replacing light bulbs, including tips for stubborn bulbs.

Bulb Specifications

Details on the type and wattage of replacement bulbs.

Troubleshooting Procedures

Unit Not Powering On

Steps to diagnose and fix issues when the unit does not turn on.

Motor Not Running with Lights On

Solutions for when the blower is not operating but lights are functional.

Unit Vibration Issues

Troubleshooting steps for excessive vibration of the unit.

Lights Not Functioning

Steps to resolve problems with the lights not working.

Improper Venting

Guidance for addressing issues with the hood not venting air correctly.

Metal Filter Vibration

Steps to fix vibration problems related to the metal filter.

List of Parts and Accessories

Replacement Parts Identification

List of part numbers for common replacement parts.

Optional Accessories Available

List of optional accessories that can enhance the unit's functionality.

Limited Warranty Information

Obtaining Warranty Service

Contact information and procedure for requesting warranty service.

Warranty Coverage Details

Explains what is covered under the parts and labor warranty.

Warranty Exclusions and Limitations

Lists items and conditions not covered by the warranty.

Related product manuals

miseno MH80120AS User Manual

Table of Contents