- page 6 -
1. Push the lock located on the top of the water cooler to open it (figure 1).
2. Remove the hygiene kit from its packing and put on the gloves to ensure hygiene (figure 2).
3. Insert the hygiene kit into the cooling room (figure 3).
4. Before inserting the receptable, place the 2 tubes towards the distributions. Insert the recepta-
ble’s notch in the right kit support’s notch (figure 4).
5. Press the cold water tap, while inserting the « cold water » tube (blue nozzle) inside the water
distribution (figure 5).
6. Then, pinch the tube in order to insert it below the notches. CAUTION: Place the notches on
the smooth part of the tube and not on the undulating part. Make sure that the tube is not
pinched. Repeat the operation for the « cook water » tube (white nozzle) (figure 6).
7. Close the top of the water cooler.
8. Remove the protecting cap of the bottle (figure 7).
9. Place the bottle as straight as possible not to avoid damaging the receptacle (figure 8).
10. Press on each tap to initiate the water inside the tubes until flowing (figure 9).
11. Switch on the water cooler.
figure 1
figure 2
figure 3
figure 4
figure 5 figure 6 figure 7 figure 8 figure 9
Cold / cook water version
To Next Page
Loading...
