Place the shaft in the clamp securely. Be sure the club
has been clamped so the shaft grip end is flush with the
clamp. If the club head is attached to the shaft, position
the club head up and centered. See image 9-1.
Press the “Power” button to turn on the DigiFlex system.
Allow the system to initialize. When the display shows
“Ready”, the DigiFlex is ready to measure.
Position the DigiFlex sensor so the laser is within ¼” of
either the front or back shaft edge or the center of the
shaft. See image 9-2.
Press the “RST” button to be sure the system is clear.
image 9-1
image 9-2
To Next Page
Loading...